Next Page

Page 1 - 4

section 1
installation

    recesses of the mount. Slide the transceiver onto the mount and push back until the mount plugs Have entered the transceiver sockets. Tighten the wing nuts on the sides of the transceiver. Refer to .315D-2 Instruction Sheet for mobile mount installation.

  2. Select location in car for mounting MP-1 Power Supply. This location must be as clean and dry as possible. Location in luggage compartment, under seat, or on passenger side of fire wall is satisfactory.

   
    Mounting in the engine compartment is not recommended.

  3. Install the power cable between the .E and the KWM-2/2A. Connect power supply speaker, and microphone as shown in figure I -4 .



    Caution

    Before making connections to the auto-mobile electrical system! make sure


figure 1-4

Next Page